5 natural ways to unclog a bathroom sink hiller how stopper plug drain fix bathtub or pop up diy plumbing troubleshooting your replace remove the old without chemicals family.

How to fix bathroom sink drain plug. Remove the screws that secure the overflow cover plate. This rod is often attached. Place the linkage rod into its hole and catch the loop at the bottom of the drain plug with.

This quick video leaves out all the unnecessary commentary and focuses on the process. Now, verify that you have a good seal. This may take time, but it will eventually clear.

Lift up on the sink stopper to pull it out of the drain, taking care to avoid damaging the stopper. After you’ve wiped everything up and cleared the drain, it’s time to put everything back together again, so reverse the process. The lever or lift knob is on or near the faucet body and connects to a lift rod.

Then, tighten the clevis screw. If you are disassembling your. Pulling the pivot rod from the tail.

Sink stoppers use levers and links to move the drain plugs up and down. You can use a funnel to make sure all of the baking soda goes. Allow your sink to drain completely.

Pull the plate and lever away from the overflow hole, partially pulling out the mechanism. Run boiling water down the sink. Adjust the nut on the.