Heat the dented area of your.

How to fix a small dent in a car hood. Clean the body of the car so that it is free from grease and dirt. Put the vacuum cleaner tube over the hole on. Poke a hole in the bottom of a container or bucket and place it over the dent.

You can hammer around the edges of the dent until it pops out. Cover the dent by the upper part of the bucket. This will help the plunger create suction.

The first is called the mallet method. For most dents you stick a pulling attachment (essentially a suction cup on the end of a long screw) into the middle of the dent. I used my friends kit and it worked a lot better then i thought!sign up for throtl vip!

Use the vacuum to suck the air out of the hole until the dent pops out. You can also try the. For this fix, you’ll remove the hood of your car and lay it upside down on a blanket.

Place the tip of the tool behind the panel with light pressure. For this dent repair procedure, take a hair dryer or some other portable heat source (but not a heat gun, which will damage the paint) and apply the heat onto the affected area. Watch the reflection to see where the tool is causing the panel to distort.

Make a small hole in the bottom of the bucket. First, heat the dent with the hairdryer approximately six inches away for about 30 seconds. This is called paintless dent removal (pdr).