The first step to filling a gap between the window trim and the wall is to measure the thickness of the gap.
How to fill gap between door trim and wall. Apply acrylic latex caulk to fill inside corners, especially when the baseboard is molded. Put a tube of caulk in a caulking gun and place the tip at the lowest part of the gap. There is a wide gap between the trim and the wall.
If your wall sticks out farther than your door jamb, there are a few ways you can fix the gap that creates. The gap between the door frame which is part of the door assembly and the studs are normal. After cutting the sweep to size, open the door and slide the sweep along the base.
Old walls and the trim around the door has. The space allows the door frame to be installed straight vertical. Take a tape measure and measure the distance between the wall.
Each nail should be spaced about 16 to 24 inches apart along the whole length of the baseboard. Tack the stripping into place. Next, measure the length of your door frame.
Next, wrap a rag or small hand towel around your index finger, then dip it into some warm water. Close the door and measure both sides of the frame with a tape measure. This type of sweep features flexible.
When i was fitting back mould/architrave, i used to cut the timber to fit exactly. Before using foam, try to make wet the wall and spray the foam. When you want to get rid of old stripping on a door, use a paint scraper to cut it away from the top, bottom, and sides.