Connect the minger dc wire to control center;
How to connect led strip lights together. Determine how many strips you will need to determine how many light strips you will need,. You can connect your led strips to a socket in two ways. There are two ways to connect them:
You can use these to. With the soldering iron, connect the wires to the led light strips. Clipping and using cable with connector to connect led strip lights way 3:
Only one connector can be connected to each device at any. Use the colored wires of the connector to. Clipping and using connectors to connect led strip lights way 2:
So if you can’t get the remedy in the video to work or you just want less hassle, please check them. To connect a strip to a controller, one end of a connector is plugged into the female port on the side of either a strip or controller. If it can’t use connectors, please.
Lightly touch the tinned part of the wire to the solder joint of the led strip. What kind of circuit should be used? The voltage of the psu and the led strip must be the same.
A step by step guide on how to connect multiple led strips to one power source step 1: Just use a sharp object like a knife, and pull. How to set up minger led lights set up the power to control center: