Do not use any soap or cleaning product that might cause damage to the.

How to clean shark navigator lift away filter. Wash it deeply and dry fully for the next time. Take out the hepa filter by pulling it straight out, turn the filter over so. Locate the filters and dust screens.

To clean the foam and/or felt filters, rinse with cold water only. Remove the filter cover from the front of the vacuum by pulling up on the tab and pulling the cover away from the vacuum. This supports the following product skus nv350, nv350a_26, nv350c_26, nv350e, nv350q,.

After that, carefully tap the filter to remove excess water. This supports the following product skus la401. Remove the dirt container and detach the felt and foam filter as well as the hepa filter.

Disconnect your vacuum from the power source. Remember if you don’t clean this fully it will cause the loss of suction. Taking out the circuit board.

Taking out the base plate. First and most importantly, make sure your vacuum is unplugged! 1 how to take apart shark navigator lift away.

When cleaning foam filters on shark vacuums, it is important to know how to do. Next, empty the contents of the dirt canister into. A good place to start is with the rotating brush underneath the vacuum.