If the button cell battery in the key fob of wrangler is replaced incorrectly or a battery is unsuitable, it can damage the vehicle key.

How to change battery in jeep wrangler key fob. Next, pry open the key fob cover (a flathead screwdriver comes in handy here). Apply pressure on the screwdriver as you pry it open. To recap, here are seven simple steps how to change the battery in your jeep key fob:

And if you are facing a key fob problem due to a bad jeep battery, the best solution is that recharge it again or simply. To do it, just follow these simple steps: Cr2450 coin battery 🪙 you need:

Since the device is composed of two plastics snaps into each other, use the flathead screw to unsnap it. Take care to note which side of the. In the past couple of weeks the second one hasn't always been locking and unlocking the…

Remove the old battery from the housing. Press down on the screwdriver to force the key apart at the seam. You’ll see the old battery, a circuit board, and a rubber keypad.

Open the top and bottom pieces. Replacing the jeep key fob battery can be simple and a lot more affordable than replacing the entire key fob. Press down lightly on the top of the screwdriver to force the two key fob segments apart at the seam.

The first step is to open the key fob to be able to get access to the battery. On the top side of the key fob, you will see. On the backside of the key fob, there is a small latch that needs to be pulled to the side to release the metallic spare key.