After you cut the string, fold the string in half, put both of the string ends through the ring.
How to attach a string of beads to chain. Tie one knot to secure the beads in place. Key chain tools, beadsmith brand, made in usa #1025a. Wrap the loop for each bead link using one pair of pliers to hold the eye of the loop and another to grasp the wire end and wrap it around the neck.
Cut your wire to that length (in my case, 6″): To make sure you grab the correct side of the loop, pull the beading. Keep the crimp about three inches away from the end of the wire.
I do it this way: But in case you do not have any needles. Now pass the other end of the cord and pull it to make a loop.
Tie this knot as close to the end of the beading as possible to keep the beads from sliding around on the string and revealing the cord beneath. Attaching chain to a string of beads. Pull the cording until the middle of the string is near the ring.
Add 2.5″ (64mm) to your total bead length we just measured. String the beads add the beads of the necklace in the order you laid out in your design. Put a crimp bead at the end of your string of beads, run string through a thread protector, pull crimp up towards the.
Be sure to cut away any extra cord near the. Prepare your thread with the needles. Welcome to our video on how to attach a clasp to either a necklace or bracelet!we hope you enjoy our videos, these were filmed a few years ago and the majori.