Tape the vinyl lettering to keep it in position.

How to apply vinyl lettering to wall. How to apply vinyl wall letters. Now that you know where you’d like to put your vinyl lettering, make sure it’s clean and dry. Custom vinyl lettering is a great way to add unique touches to your.

Go over the area several times with the card to make sure that the vinyl is applied firmly. How to apply vinyl lettering 1. Continue heating specific sections of the as you apply it.

On a flat table, with the application tape side up, use your squeegee to wipe over the whole of the. Lower the mask layer and press firmly at a 45 degree angle using your squeegee. Peel up one side of the transfer tape and cut away the vinyl backing.

Apply the vinyl lettering to the surface. Place the tape along the top edge of the sticker, half on the sticker and half on your wall. Start from the middle and work your way out.

Wet application you can not install with the form of letters on the wall or reflective vinyl. Starting in the middle, smooth the vinyl outward. You can see the full instructions here:

Slowly and very carefully remove the transfer tape by folding it back onto itself and exposing each letter underneath. Carefully run a hair dryer on low power back and forth over both the wall and your decal. Place your vinyl lettering, right side up so that it is readable, on a table or flat surface.