If your strap has a metal ferrule, put the ferrule back where the strap connects, and then insert the pin back into the hole.

How to adjust a watch band with pins. It's a segmented metal band with a deployment clasp. Gentle push down over the watch face, so the plate lifts up. Set up your workspace so that it is fully illuminated and comfortable to sit or stand at.

Get a tool like a thin screwdriver and insert it in the little gap on the clasp. This will make sure the watch itself stays centered on the wrist band. Unless you have tools and skills you probably cannot.

Set the end link aside because. Firmly hold the watch, and using your dominant hand, place the forked end of the. Advertisement 3 get your tools.

Every guide i've found to adjusting watch bands says to find arrow markings and pins on the side, but none of these are visible on the. Use the hammer to gently. After all of the required body links are removed, you can put the watch band pins back in the pinhole from the same side of the link that you.

In this way, you can access it to calculate the width of the spikes. I bought a box of various different. Afterwards, bend the end link inwards to remove it.

Use your fingers to make a v and gently spread the band apart where you want to remove links.use a spring bar tool or small. When you cannot push the pin pusher any further into the band, set it aside and remove the watch band from the holder. Write down the number of links that need to be removed from either side of the clasp.