$1,395.00 buy now from amazon.

Hayward pump and filter setup. After plugging in the filter, it is time to add the d.e. The backwash setting will be the multiport valve position you will use the second most frequently, after the filter setting. Water should go from pool to pump strainer basket, then through the pump, outlet from pump connected where you have the big loop on the front of the filter below the pressure.

Unlike traditional pumps that do not come with connectors, the hayward sp2310x15 comes with 1.5” by 2” union connections for enhanced efficiency when moving water through the filtration. Manuals to view these documents, you will need to download the free acrobat reader, which gives you instant access to pdf files. Subwoofer filter circuit diagram pdf.

Floor or wall), must be installed a minimum of three feet (3’) [1 meter] apart, as measured from near point to near point. Installation of pump and suction outlets must be in compliance with all applicable local building codes. Start to slowly peel back your cover, folding it in halves as you do, for easy removal.

The majority of our literature and brochures. Connect the pool return plumbing to the outletport at the bottom of the filter body. Connect the pool suction plumbing between the skimmer and the pump.

Once the pool cover is off, lay it out and sweep it off before cleaning it thoroughly with soap and water. Once you’re done vacuuming, clean the pump strainer basket of any debris. Pump and filter upgrade for beginners

Turn on the pump and the dirty water will flow out the waste line. Backwash the filter as needed. Water sensor this sensor is used to measure the pool/spa temperature and is installed in the filtration plumbing after the filter but before either the solar or conventionally fueled heaters.