Instructions get an old magazine or newspaper cut out a rectangle about the size of your skateboard flip over your board and find out where you will place it on the wall.

Hanging skateboard on wall. Next, add in nuts, one on each bolt again, about halfway. There you have it, a. Take the shoelace and place it to the.

Another way to hang a skateboard on the wall is to use a rope instead of a fishing line. In this method to hang a skateboard, you need to remove the skateboard’s trucks. To mount your deck, attach it to the wall using a pack skateboard wall mount, including hangers and screws.

It’s best to have a drill with a 3/8″ drill bit and a hammer drill to make sure that the holes. A spanner can be used for tightening these nuts. The wheels of the deck should be secured with the right grip, and you will be able to hang them correctly.

A cheap and easy diy way to hang skateboards on your wall. Place a washer over each of the bolts on the front side of the plate and secure them with a nut. Clean the wall surface where you will be attaching the adhesive strips.

Everything you need to know to do this diy. Make sure that by holding the fishing line, the. The fishing line is a common and old method that is.

Do the same for the other knot and screw. Peel the backing off of one side of an adhesive strip. Use a 7mm spanner wrench to tighten the nuts better and secure them in their places.