Screw the plywood plate into the.
Hanging skateboard decks on wall. Next up, you need to measure the distance between the holes in your skateboard deck (where the trucks go). Place two more nuts on the long. Next, add in nuts, one on each bolt again, about halfway.
Hanging a skateboard deck using a rope. Make a mark on the wall where you want your screw to go in. Place a washer over each of the bolts on the front side of the plate and secure them with a nut.
Mount the pushpin to the wall. Use a 7mm spanner wrench to tighten the nuts better and secure them in their places. In this video i show you how i hung up my boards.
Do the same for the other knot and screw. Take the shoelace and place it to the bottom hole of a skateboard and take it off from the deck’s backside. A screw should be included with your deck display.
These two additional bolts mark the gap between. Lastly set the loop directly to the rear part of the deck. Once you have the measurement, you will need to draw two dots (the.
Bear in mind that where the screw is will be slightly above the top holes of your board. This is a quick and easy way to do it. Hold the display against the wall and align the hole at the center with the one you drilled in the wall.