Lay the first tile in line with reference point.

Floor tiles installation procedure. Add an additional 10 so you have extra in case of broken tile or mistakes. Let the mortar dry for at least 24 hours and avoid. All cutting of tiles by high speed cutter is to be neatly carried out and suit site formation/edge.

Work from the edges of the room toward the center. Tiles are decorative as well as adds a water insulating feature to the floor or to the walls. If installing in a bathroom, remove the toilet.

Unload of tiles by mechanical means and stored. Square the area and establish reference points on substrate. Installing tiles too close can cause popping up of tiles.

The tile should be allowed to dry overnight to set. Remove the spacers between the tile, and press grout into the joints with a rubber float and then pull the grout across the lines diagonally, removing the. Push grout into the joints by first moving the float in line with the joints, then diagonal to them.

Are in place, the installer will verify the floor in both directions to balance the room. I take you through all the st. Repeat this procedure for the other edges and use tape around the base of pedestal and any other.

The procedure for polishing this type of flooring is the same as that of mosaic tile flooring and tiles fixing work procedure. Below tile installation method details construction procedure or method statement for floor tiles installation which can be used for any kind of ceramic tiling works. The installer will precisely cut the tile in order to achieve a seamless look at the edges.