To fill up the pool in the standard way, you will need to connect a hose to your outdoor spigot.

Filling above ground pool with well water. This is usually the best and most convenient water to use to fill your pool. Connect the hose to the tap nearest to the well pump. Check the wells water flow rate.

#4 · may 10, 2015. This treatment could last up to five days and requires. Attach the garden hose to the.

Place the open end of the hose inside your pool. In other words, a well can’t expel more water than it takes in. Around 600 gallons per hour would be considered a high flow rate, and anything lower than about 150 gallons per hour would be.

Get one pound of the ascorbic acid,. You need to test the pool water for ph and chlorine. It just involves putting up the water hose directly into your swimming pool.

There are two good reasons to consider using well water to fill your swimming pool, or even just to top it up: For natural pools, the most famous and easy way to treat a pool filled with well water is through chlorine based shock. We fill our pool (10,000 gallons) using the well and a garden hose.

Turn on the hose and fill the pool with water until the level of water reaches the center of the entry to the weir, then turn off the hose. You’ve left the water on for hours and now the pool is full, but the water inside your home is starting to turn brown. Here are the seven standard steps to fill your swimming pool with water: