I put two new spark plugs to see if had a spark the back up that i have.
Evinrude outboard no spark. The wires going in can be broken off inside the connector or the pins can be pushed out when reconnecting them. When igition coil primary wire is disconnected a 15 volt pulse is seen with oscilloscope. Did you verify that the coils are connected to the proper set of points.
One further step down this path is to spray the engine with an electrical spray cleaner solution of some kind. However before screwing the new one back into the engine hook it up to the spark plug wire pull the cord and see if you get a spark at the tip of the plug. Speed limiting operator warning function that limits the.
You havent answered my original question. Friend of mines think its the power pack. One possible problem area to check would be the Amphenol connectors.
I replaced the fuel pump new plugs and nothing then I bought a spark plug tester and found out Im getting no speak at the plugs. Results 1 to 12 of 12 Thread. A reading of at least 05V or more from the white wire to the blue green and purple wires while connected to the pack is needed to fire the pack.
I doubt your problem is with no spark and more with the starter not cranking properly. No Spark would most likely be stator ignition switch or pack. When low spark is detected on a plug it might be time to replace a coil.
Start by disconnecting the stop wire BlackYellow wire on the powerpack and re-test. O T Evinrude outboard no spark. If ok the ignition switch shift switch or harness has a problem.