Fdis report on voting 77/295/fdis 77/298/rvd full information on the voting for the approval of this standard can be found in the report on voting indicated in the above table.

En 61000 6 2. B) ergänzung im abschnitt 1. Contact discharge involves discharging an esd pulse directly from the esd test gun that is touching the device unde r test. If prod­uct do not have any.

This document may not be reproduced except in full, without approval Immunity requirements in the frequency range 0 hz to 400 ghz are covered. The results of the tests, calibrations and/or measurements included in this document are traceable to australian/national standards.

Or download the pdf of the directive or of the official journal for free This standard can be used in part for the presumption of compliance to the eu emc directiveread. >95%, 5000 ms >95%, 250 periods voltage interruptions 1 900 mhz is referenced in en standards only.

Applies to electrical and electronic apparatus intended for use in industrial environments, as described below. Or download the pdf of the directive or of the official journal for free this website uses cookies to ensure you get the best experience on our website. The en 61000 6 2 test method applies to apparatus which are battery operated.

Immunity requirements in the frequency range 0 hz to 400 ghz are covered. Immunity requirements in the frequency range 0 hz to 400 ghz are covered. Inter­na­tional stan­dard en 61000‒6‒2:2005 is applic­a­ble for elec­tri­cal equip­ment, that is used or intended to be used in indus­trial envi­ron­ment sup­plied by high or medium volt­age trans­former, or for equip­ment that is intended to oper­ate near to indus­trial envi­ron­ment.