Cut the fleece as shown.

Diy gaiters. Place one mask with the right side of the fabric facing upwards on a flat surface. Add 4 inches to each of the measurements and then record them for later use. Fold it in half, mark nine centimetres out from the fold and rule a line from there down to the other corner.

Sew with ¼ seam allowance the short ends of the fabric. Measure once at the shin, and again around the calf. Press the gaiter with a lot of seam on the hem and the side seams to bring any stretched areas back to shape.

This is the length of the gaiter fabric. If you wanted to hem the sides to prevent unraveling, you’ll want to hem the 18.5 inch sides. Mark out and cut a rectangle 22cm high and 40cm wide.

The boot lock is hooked into the laces and will hold the gaiter in place and prevent it from rolling up. Gaiters pros when walking through deep snow,. Place your pattern on the.

Draw one vertical line on paper representing. Gather your paper/newspaper, measuring materials, pen, and scissors. Fold the 18.5” side of the fabric in half with the print sides (right sides) facing each other.

May 13, 2019 #1 great suggestion posted. So layout the top and cut 11″ down from the bottom. A scrap of cotton or some other woven fabric.