Don't cut anywhere else but the marked line.

Cutting and connecting led strips. Cut the strip to a suitable position. Yes, your led strips will continue to work even after they have been cut down provided that they are cut along designated lines. The strip can only be cut at the points that are marked.

Peel off the tape of the 3m adhesive about a ¼ of an inch. Since most led light strips come with a. Melt a little solder on the led strip.

Melt the solder into each wire. This extra length is so you can strip the casing. First, check the led strip lights by connecting them to a power source as cutting or soldering finishes your warranty period.

The ideal place to cut in a led strip is the copper connections located at every two inches of the led strip. Place and solder the wires on the led strip noting which color you solder. These cut points are clearly shown by a line across the strip as you can see here the cutting distance for led strip varies.

Peel off the glue at both ends to expose the pcb board. After cutting the led strip light , we need a wire to strip light connector.then we can connect the led strip light with power supply.first,we need to open the connector clip.second,we need to. Insert the heat tube over the wire before soldering.

First, measure the place or thing you will out your led light strips. If you need to reconnect, remove the plastic on the end to reveal the. The next step, determine the length of the strip.