Then nail the other piece about 2 from that.

Cutting aluminum fascia. The short blade edge should be. Make sure the cuts are random and are not so deep that the aluminum snaps off. At the bottom of the trim mark the.

Cut the bottom angle of the aluminum fascia trim and put it back up, slipping the long edge of the trim beneath the metal flashing that covers the top of the gable fascia board. Aluminum soffit upside down and in. Measure & cut the aluminum fascia trim.

A guide to installing aluminum fascia on a hip roof and also a gabel end. 2) slip the cut and formed piece of aluminum for the eaves fascia behind the drip edge. Use the brake or combination square as your straight edge and lightly cut into the material with a blade or utility knife.

Cut a piece of the aluminum trim coil about 1.5 times the width and three times the length of the fascia board. Using metal cutting snips trim the top section at your mark. Measuring the 75″ which i will use as a reference for the coil.

Now take the aluminum fascia and place it on the work surface. Measure 1 to 1.5 inches in on the short side of the aluminum fascia. Aluminum flashing protects the fascia board of your home from the elements.

If you do not have a manual. Put the fascia board, with the clip facing down, on a flat, firm surface. Align the long blade edge of the metal framing square with the length mark placed on the aluminum soffit in step 1.