The tape helps prevent chipping when cutting and can be used on a jigsaw’s metal shoe plate, preventing scratching against the plexiglass.

Cut acrylic with jigsaw. Most saws can be used. Position the jigsaw on one end of the cut, taking care to align the jigsaw on the cutting line. Here are the steps involved in cutting acrylic sheet using a circular power saw.

The accuracy for cutting acrylic with a jigsaw is easier than with a table saw due to how these different power tools work. Cover your cut line by spearing a tape directly through it. How to cut acrylic (plexiglass) by eplastics.com.

Use a scoring knife to cut a narrow groove in the acrylic sheeting. This could end up in breakage, melting, and burs. A bandsaw is often known for its ability to cut curves and.

Please read as well as adhere to the manufacturer's health and wellness. Whereas for acrylic up to 4mm in thickness, you could simply use a scriber and the blow. In principle, both circular hand saws and jigsaws are suitable for most acrylic sheet grades.

Choosing the right blade is a vital part of the preparation because a blade that’s not fine enough will only chew up the plexiglass. Mark the cut line with a marker or a grease pen. Check that the shoe is set down flat on the surface of the workpiece, and that the blade is not.

Measure the length of the acrylic you intend to cut, using a ruler. If you begin at a low speed, this could lead. Keep away from positioning right into the plexi with the jigsaw.