To clear a cloudy above ground pool, the ph levels must fall between 7.3 and 7.6.

Clean above ground pool filter. Next, soak the filter in a bucket of pool filter cleaner. The pool filter cartridge can be cleansed of coarse dirt and debris by pressure washing inside and out with a garden hose. Pour your sand filter cleaner into the strainer basket, putting the lid back on.

You can now put it. The scrubbing brush, as well as the net, may be used to remove all varieties of algae. Your pump and filter are designed to clean your pool.

With your backwash hose connected, turn off the pump, and move the valve to the “backwash” position. First, turn off the filter system. However, borax is primarily used to combat green algae, while baking.

Do not use soap or detergent. If the ph level is too low, then the water will be acidic. Just follow the below steps to get backwashing:

Then you may be back learning how. This video will show you how to use the different settings to backwash and clean your above ground pool sand filter.in the swim pool product offer: This can corrode the pool’s.

Open the air relief valve. After soaking, rinse the filter off again with fresh water. Do not use abrasive cleaners.