It will be easiest to do so where the keyring mount is.
Changing a battery in a jeep key fob. 3, take out the old battery from the. Slide the latch that releases the key from your fob and remove the key use a flathead screwdriver or the key itself to gently pry. Replacing the jeep key fob battery can be simple and a lot more affordable than replacing the entire key fob.
Press down lightly on the top of the. Slide the switch over to release. Remove the old battery from the housing.
Open the top and bottom pieces. Take out the battery and swap it for a new cr2032 battery. Turn over the key fob and locate the metal switch.
You’ll see the old battery, a circuit board, and a rubber keypad. And if you are facing a key fob problem due to a bad jeep battery, the best solution is that recharge it again or simply. Tools needed in replacing jeep key fob battery when replacing your key fob’s battery, you do not need many tools to do it successfully.
Take care to note which side of the. 2, open the key fob at the seam by using the screwdriver. To replace the battery, follow these steps:
0 response to changing battery in jeep key fob post a comment. To do it, just follow these simple steps: Use the screwdriver to pry the key fob apart at the seam.