Wet the mounting surface and press the active face of the transducer against the hull.

Boat depth finder with in hull transducer. Manufacturers frequently recommend using epoxy or similar substance if you decide to bond a transducer to the inside of the hull. It is also important that you acknowledge the fact that the performance of your fish finder device largely hinges on whether your transducer is appropriately mounted on the bottom of your boat. You will need to set the keel offset to zero.

Same Assessment New Name. 200W 200 kHz In-Hull Mount Transducer for all HawkEye Boat Mount Depth Finders without Temperature. Once good depth readings at speed are found reduce the boat speed and check the location at slow speed again.

This is a genuine Mercury Marine factory OEM part not aftermarket. HDR650 Depth Finder with Transom Mount Transducer by Humminbird. Mounting Depth Finder Transducers Inside the Hull.

Euro 2 Black DialBlack Aluminum Bezel In-Dash Mount Depth Gauge with In-Hull Transducer 12851 by Faria Beede Instruments. Can be installed while the boat is in the water. Repeat this process until a good location for the transducer is found.

I made a little plywood box to put over so it doesnt get knocked. No matter how I adjust the transducer or move it I loose the bottom at about 10MPH. Before the scheduled haulout make sure you have the correct transducer.

If its ON the KO icon will be illuminated on the depth finder display. Just to try it out I stuck it a bed of vaseline inside the glassply hull of my boat. Note the depth that is being displayed on the Depth Sounder.