Continue to wait 5 to 10 minutes before rinsing the.
Black shirt bleach design. Spray a little bleach down onto the shirt and wait. Print it on sublimation paper and cut it out leaving at least.25 inches (0.64 cm) of edge space.; I make my mixture an equal amount of water.
Insert a section of cardboard inside the shirt, behind the vinyl stencil. From there, you need to bind the whole. Plug your iron in so it starts to warm up.
Mix half bleach and half water in a spray bottle. Take a piece of cardboard (removing any tape or stickers) and tuck it inside the shirt. The printing looked terrific, was well priced, and got here promptly.
Make sure the nozzle is on the mist setting. See more ideas about bleach shirts, bleach shirt diy, diy shirt. The corner is your starting point.
Place a piece of cardboard in your. Lint roll it again, then heat press it for a few seconds. Do whatever is easiest and works for you!
See more ideas about diy clothes, diy fashion, bleach shirts. Lay down your design over the bleached area and tape it down with heat tape. Mix a 50/50 ratio of water and chlorine bleach in a spray bottle.