Bissell carpet cleaner leaves streaks.

Bissell proheat will not spray. The sprayers do not spray and brushes( rollers) do not. In case the machine cleans the carpet and leaves behind streaks, the following troubleshooting steps could help you fix the problem. The brushes dont turn but the vac motor does suck.

The bissell machine has a pump that helps pump the water out of the machine. If there is air in the pump where water should be, as there was when the machine was used for the first time, you. Hook nozzle into the groove at the bottom of the.

As with all pumps, the pump on the bissell 2x proheat needs to be primed. One of the reasons your bissell pro heat protech is not spraying cleaning solution. Check if your bladder is empty, this could be the reason bissell is not spraying water on the floor.

Press the recline pedal to lay down the machine handle. Bissell proheat 2x revolution not spraying water on floor water tank is not filled up. If you mark that the soap solution is not spraying, turn off your bissell carpet cleaner as early as possible.

Although this might seem silly to some, this is often the case. Pull the plastic lever on. The most common cause is that the water tank is empty.

Lift the handle from the water compartment at the front of the proheat cleaner. You just want to make sure that you don’t get any of the bristles wet. Remove the bissell’s water tank.