Wipe them dry with a clean cloth.

Adjust garage door sensors. Garage door sensors run on batteries, which is likely due to low. This is located on the side of the motor unit, near. Loosen the bolts with a wrench or socket set, but do not remove them altogether.

Genie garage door openers may be programmed to identify when the door is entirely closed. Close the door and then hold the button to open it. This blog post will show you how to align garage door sensors in ten easy steps!

Unscrew the screws holding the sensors. Turn the power back on and test the alignment. Pull this ribbon through the doorway and center it on the other sensor.

Finally, turn the power back on and test your alignment by clicking the garage door button. If it opens more than five feet but does not open all the way, then it. Check the sensors to see if they are dirty.

Tie a ribbon to one of the sensors so it’s centered on the sensor when pulled through the doorway. Press the control button to close the door. You need to activate the carriage assembly.

Disconnect power supply to the garage. Clean the units, carefully wiping the lenses free of dirt, dust or cobwebs with a damp cloth. Firstly, you’ll need to cut off the power to your garage door properly.